Mediant 800B MSBR
63
Data-Router Debugging
# ping <ip address> source voip interface [interface name] repeat size
[YL] in ipv4 you can ping from both voip or data interfaces
63.1
Loopback on WAN Interface Debugging
You can perform loopback testing on the WAN interface for debugging purposes. Loopback
debugging can be activated on any WAN interface (name or type).
To perform loopback testing, use the following CLI command:
# debug ethernet loopback interface <interface name / type>
For example:
# debug ethernet loopback interface GigabitEthernet 0/0
The no debug command disables the loopback test.
Note:
enabled.
Version 6.8
All communication through the loopback WAN interface stops when this test is
753
63. Data-Router Debugging
Mediant 800B MSBR