AudioCodes Mediant 800B MSBR User Manual page 272


To configure an IP Group:
1. Open the IP Group Table page (Configuration tab > VoIP menu > VoIP Network >
IP Group Table).
2. Click Add; the following dialog box appears:
3. Configure an IP Group according to to the parameters described in the table below.
4. Click Submit, and then save ("burn") your settings to flash memory.
Parameter
Common Parameters
Index
[IPGroup_Index]
Type
CLI: type
[IPGroup_Type]
User's Manual
Figure 21-5: IP Group Table - Add Dialog Box
Table 21-5: IP Group Table Parameter Descriptions
Defines an index for the new table record.
Defines the type of IP Group:

[0] Server = Used when the destination address,
configured by the Proxy Set, of the IP Group (e.g., ITSP,
Proxy, IP-PBX, or Application server) is known.

[1] User = Represents a group of users such as IP
phones and softphones where their location is
dynamically obtained by the device when REGISTER
requests and responses traverse (or are terminated) by
the device. These users are considered remote (far-end)
users.
Typically, this IP Group is configured with a Serving IP
Group that represents an IP-PBX, Application or Proxy
server that serves this User-type IP Group. Each SIP
Description
272
Mediant 800B MSBR
Document #: LTRT-12813