AudioCodes Mediant 800B MSBR User Manual page 862

Parameter
EMS: V32 Transport
CLI: V32-modem-transport-type
[V32ModemTransportType]
Web: V.34 Modem Transport
Type
EMS: V34 Transport
CLI: V34-modem-transport-type
[V34ModemTransportType]
EMS: Bell Transport Type
CLI: bell-modem-transport-type
[BellModemTransportType]
Web/EMS: Fax CNG Mode
CLI: fax_cng_mode
[FaxCNGMode]
Web/EMS: CNG Detector Mode
CLI: coder
[CNGDetectorMode]
Web: Fax Detect Timeout Since
Connect (msec)
User's Manual

[2] Enable Bypass (default)

[3] Events Only = Transparent with Events.
Notes:

This parameter applies only to V.32 and V.32bis modems.

You can also configure this functionality per specific calls,
using IP Profiles (IpProfile_VxxTransportType). For more
information, see ''Configuring IP Profiles'' on page 314.
Determines the V.90/V.34 modem transport type.

[0] Disable = Transparent.

[2] Enable Bypass (default)

[3] Events Only = Transparent with Events.
Note: You can also configure this functionality per specific calls,
using IP Profiles (IpProfile_VxxTransportType). For more
information, see ''Configuring IP Profiles'' on page 314.
Determines the Bell modem transport method.

[0] = Transparent (default)

[2] = Bypass

[3] = Transparent with events
Determines the device's handling of fax relay upon detection of a
fax CNG tone or a V.34/Super G3 V8-CM (Call Menu) signal from
originating faxes.

[0] Doesn't send T.38 Re-INVITE = (Default) SIP re-INVITE is
not sent.

[1] Sends on CNG tone = Sends a SIP re-INVITE with T.38
parameters in SDP to the terminating fax upon detection of a
fax CNG tone, if the CNGDetectorMode parameter is set to 1.

[2] Sends on CNG or v8-cn = Sends a SIP re-INVITE with
T.38 parameters in SDP to the terminating fax upon detection
of a fax CNG tone (if the CNGDetectorMode parameter is set
to 1) or upon detection of a V8-CM signal.
Notes:

If this parameter is set to [2] and the CNGDetectorMode
parameter is set to [0], the device sends a re-INVITE only if it
detects a V8-CM signal from the originating fax.

This feature is applicable only if the IsFaxUsed parameter is
set to [1] or [3].

The device also sends T.38 re-INVITE if the
CNGDetectorMode parameter is set to [2], regardless of the
FaxCNGMode parameter settings.
Global parameter that enables the detection of the fax calling
tone (CNG) and defines the detection method. You can also
configure this functionality per specific calls, using IP Profiles
(IpProfile_CNGmode). For a detailed description of this
parameter and for configuring this functionality in the IP Profile
table, see ''Configuring IP Profiles'' on page 314.
Note: If this functionality is configured for a specific IP Profile, the
settings of this global parameter is ignored for calls associated
with the IP Profile.
Defines a timeout (in msec) for detecting fax from the Tel side
during an established voice call. The interval starts from when the
voice call is established. If the device detects a fax tone within the
862
Mediant 800B MSBR
Description
Document #: LTRT-12813