AudioCodes Mediant 800B MSBR User Manual page 276

Parameter
CLI: Msg-Man-User-Defined-String2
[IPGroup_MsgManUserDef2]
Gateway Parameters
Always Use Route Table
CLI: always-use-route-table
[IPGroup_AlwaysUseRouteTable]
Routing Mode
CLI: routing-mode
[IPGroup_RoutingMode]
SIP Re-Routing Mode
CLI: re-routing-mode
[IPGroup_SIPReRoutingMode]
User's Manual
Description
For configuring Message Manipulation rules, see
''Configuring SIP Message Manipulation'' on page 299.
Defines a value for the SIP user part that can be used in
Message Manipulation rules configured in the Message
Manipulations table. The Message Manipulation rule
obtains this value from the IP Group, by using the following
syntax: param.ipg.<src|dst>.user-defined.<1>.
The valid value is a string of up to 30 characters.
For configuring Message Manipulation rules, see
''Configuring SIP Message Manipulation'' on page 299.
Defines the Request-URI host name in outgoing INVITE
messages.

[0] No (default).

[1] Yes = The device uses the IP address (or domain
name) defined in the Outbound IP Routing table (see
Configuring the Outbound IP Routing Table on page
397) as the Request-URI host name in outgoing INVITE
messages, instead of the value configured in the 'SIP
Group Name' field.
Note: This parameter is applicable only to Server-type IP
Groups.
Defines the routing mode for outgoing SIP INVITE
messages.

[-1] Not Configured = (Default) The routing is according
to the selected Serving IP Group. If no Serving IP Group
is selected, the device routes the call according to the
Outbound IP Routing table (see Configuring Outbound
IP Routing Table on page 397).

[0] Routing Table = The device routes the call according
to the Outbound IP Routing table.

[1] Serving IP Group = The device sends the SIP
INVITE to the selected Serving IP Group. If no Serving
IP Group is selected, the default IP Group is used. If the
Proxy server(s) associated with the destination IP Group
is not alive, the device uses the Outbound IP Routing
table (if the parameter IsFallbackUsed is set 1, i.e.,
fallback enabled - see Configuring Proxy and
Registration Parameters on page 296).

[2] Request-URI = The device sends the SIP INVITE to
the IP address according to the received SIP Request-
URI host name.
Notes:

This parameter is applicable only to the IP-to-IP
application.

This parameter is applicable only to Server-type IP
Groups.
Defines the routing mode after a call redirection (i.e., a 3xx
SIP response is received) or transfer (i.e., a SIP REFER
request is received).

[-1] Not Configured (Default)
276
Mediant 800B MSBR
Document #: LTRT-12813