Triggers For Automatic Update; Access Authentication With Http Server - AudioCodes Mediant 800B MSBR User Manual

47.2.3 Triggers for Automatic Update

The Automatic Update feature can be triggered by the following:

When the device is initially deployed (first-time deployment) in the network. This
trigger is referred to as Zero Configuration (see Zero Configuration on page 646).

Upon device startup (reset or power up). To disable this trigger, run the following CLI
command:
(config-system)# automatic-update
(automatic-update)# run-on-reboot off

Periodically:
•
Specified time of day (e.g., 18:00), configured by the ini file parameter
AutoUpdatePredefinedTime or CLI command configure system > automatic-
update > predefined-time.
•
Interval between Automatic Updates (e.g., every 60 minutes), configured by the
ini file parameter AutoUpdateFrequency or CLI command configure system >
automatic-update > update-frequency.

Centralized provisioning server request:
•
Upon receipt of an SNMP request from the provisioning server.
•
Upon receipt of a special SIP NOTIFY message from the provisioning server. The
NOTIFY message includes an Event header with the AudioCodes proprietary
value, "check-sync;reboot=false", as shown in the example below:
NOTIFY sip:<user>@<dsthost> SIP/2.0
To: sip:<user>@<dsthost>
From: sip:sipsak@<srchost>
CSeq: 10 NOTIFY
Call-ID: 1234@<srchost>
Event: check-sync;reboot=false
To enable this feature through the Web interface:
a.
b.
c.
To enable through CLI: configure voip > sip-definition advanced-settings > sip-
remote-reset.

47.2.4 Access Authentication with HTTP Server

You can configure the device to authenticate itself with the HTTP/S server. The device
authenticates itself by providing the HTTP/S server with its authentication username and
password. You can configure one of the following HTTP authentication schemes:

Basic Access Authentication: The device provides its username and password to
the HTTP server. The username and password is configured in the URL that you
define for downloading the file:
•
ini file:
AutoCmpFileUrl = 'https://<username>:<password>@<IP address
or domain name>/<file name>'
•
CLI:
# configure system
(config-system)# automatic update
(automatic-update)# auto-firmware
https://<username>:<password>@<IP address or domain
name>/<file name>
User's Manual
Open the Advanced Parameters page (Configuration tab > VoIP menu >
SIP Definitions > Advanced Parameters).
Under the Misc Parameters group, set the 'SIP Remote Reset' parameter to
Enable.
Click Submit.
636
Mediant 800B MSBR
Document #: LTRT-12813