AudioCodes Mediant 800B MSBR User Manual page 398

•
Source and destination Request-URI host name prefix

Destination: If the call matches the configured characteristics, the device routes the
call to an IP destination. If no characteristics match is found in the table, the call is
rejected. The destination can be any of the following:
•
IP address in dotted-decimal notation.
•
Fully Qualified Domain Name (FQDN).
•
E.164 Telephone Number Mapping (ENUM service).
•
Lightweight Directory Access Protocol (LDAP). For a description, see Routing
Based on LDAP Active Directory Queries on page 210.
•
IP Group, where the call is routed to the IP address configured for the Proxy Set
or SRD associated with the IP Group (configured in ''Configuring IP Groups'' on
page 270). If the device is configured with multiple SRDs, you can also indicate
(in the table's 'Dest. SRD' field) the destination SRD for routing to one of the
following destination types - IP address, FQDN, ENUM, or LDAP. If the SRD is
not specified, then the default SRD (0) is used. In scenarios where routing is to
an IP Group, the destination SRD is obtained from the SRD associated with the
IP Group (in the IP Group table). The specified destination SRD determines the:
♦
♦
♦
Since each call must have a destination IP Group (even in cases where the
destination type is not to an IP Group), in cases when the IP Group is not specified,
the SRD's default IP Group is used, which is the first configured IP Group that belongs
to the SRD.
User's Manual
Destination SIP interface (SIP port and control IP interface) - important when
using multiple SIP control VLANs
Media Realm (port and IP interface for media / RTP voice)
Other SRD-related interfaces and features on which the call is routed
Figure 28-1: Locating SRD
398
Mediant 800B MSBR
Document #: LTRT-12813