Installing Software License Key Using Cli - AudioCodes Mediant 800B MSBR User Manual

4. Verify that the Software License Key was successfully installed, by doing one of the
following:
•
In the Software Upgrade Key Status page, check that the listed features and
capabilities activated by the installed Software License Key match those that
were ordered.
•
Access the Syslog server and ensure that the following message appears in the
Syslog server:
"S/N___ Key Was Updated. The Board Needs to be Reloaded with ini file\n"
5. Reset the device; the new capabilities and resources enabled by the Software License
Key are active.
Note: If the Syslog server indicates that the Software License Key was unsuccessfully
loaded (i.e., the "SN_" line is blank), do the following preliminary troubleshooting
procedures:
1. Open the Software License Key file and check that the "S/N" line appears. If it
does not appear, contact AudioCodes.
2. Verify that you have loaded the correct file. Open the file and ensure that the first
line displays "[LicenseKeys]".
3. Verify that the content of the file has not been altered.

46.2.2.2 Installing Software License Key using CLI

To install the Software License Key using CLI, use the following commands:

To install the Software License Key:
(config-system)# feature-key <"string enclosed in double
quotation marks">

To view the Software License Key:
show system feature-key
User's Manual 624
Mediant 800B MSBR
Document #: LTRT-12813