AudioCodes Mediant 800B MSBR User Manual page 652

MSBR# configure data
MSBR(config-data)# interface GigabitEthernet 0/0
MSBR(conf-if-GE 0/0)# ip address 100.0.10.10 255.255.0.0
MSBR(conf-if-GE 0/0)# exit
MSBR(config-data)# exit
MSBR# configure system
MSBR(config-system)# cli-terminal
MSBR(cli-terminal)#
activate defaults exit help
history list pwd quit
set
MSBR(cli-terminal)# set ssh on
MSBR(cli-terminal)#
activate defaults exit help
history list pwd quit
set
MSBR(cli-terminal)# set wan-ssh-allow on
Note: Setting this parameter requires a reset.
MSBR(cli-terminal)*# exit
MSBR(config-system)*# exit
MSBR*# write
Writing configuration...done
MSBR*#

To automatically provision the device using a USB flash drive:
1. Using a basic text-editing program such as Notepad, create a new text file.
2. Type the desired CLI commands in the file.
3. Save the file as "ac_autorun.txt".
4. Copy the file to a USB flash drive. The USB must be formatted to the FAT32 file
system.
5. Power up the device.
6. Plug the USB flash drive into the device's USB port, located on the front panel; the
device runs the "CLI session".
7. When the STATUS LED starts to flash red, remove the USB flash drive from the USB
port. This indicates that the device has finished running the CLI script.
8. If required, view the results (output) of the "CLI session" in the ac_output.txt, which the
device sent to the USB flash drive.
User's Manual 652
Mediant 800B MSBR
Document #: LTRT-12813