AudioCodes Mediant 800B MSBR User Manual page 131

User's Manual
The device is shipped with a default OAMP interface. For more information, see ''Default
OAMP IP Address'' on page 29. The Interface table lets you change this OAMP interface
and configure additional network interfaces for control and media, if necessary. You can
configure up to 12 interfaces, consisting of up to 11 Control and Media interfaces and 1
OAMP interface. Each IP interface is configured with the following:

Application type allowed on the interface:
•
Control: call control signaling traffic (i.e., SIP)
•
Media: RTP traffic
•
Operations, Administration, Maintenance and Provisioning (OAMP): management
(i.e., Web, CLI, and SNMP based management)

IP address (IPv4 and IPv6) and subnet mask (prefix length)

Complementing this network configuration is the On-Board Ethernet Switch
configuration. This enables you to configure the VLAN IDs accessible through each
physical port, as well as the Native VLAN ID per physical port. Layer3 (DiffServ) and
Layer 2 (VLAN priority) Quality of Service parameters can also be configured. For
configuring Quality of Service (QoS), see ''Configuring the QoS Settings'' on page 142.

Default Gateway: Traffic from this interface destined to a subnet that does not meet
any of the routing rules (local or static) are forwarded to this gateway

Primary and secondary domain name server (DNS) addresses (optional)

Underlying Ethernet Device: Layer-2 bridging device and assigned a VLAN ID.
Multiple entries in the Interface table may be associated with the same Ethernet
Device, providing multi-homing IP configuration (i.e., multiple IP addresses on the
same interface/VLAN).
Complementing the Interface table is the Static Route table, which lets you configure VoIP
network static routing rules for non-local hosts/subnets. For more information, see
''Configuring Static IP Routing'' on page 139.
Notes:
•
Before configuring IP interfaces, it is recommended that you read the IP interface
configuration guidelines in ''Interface Table Configuration Guidelines'' on page
135.
•
The IPv6 feature is available only if the device is installed with a Software License
Key that includes this feature. For installing a Software License Key, see Software
License Key on page 621.
The following procedure describes how to configure the IP network interfaces in the Web
interface. You can also configure IP network interfaces using the table ini file parameter,
InterfaceTable or CLI command, configure voip/interface network-if.
Version 6.8 131
16. Network
Mediant 800B MSBR