AudioCodes Mediant 800B MSBR User Manual page 740


To configure a test call:
1. Open the Test Call Table page (Configuration tab > System menu > Test Call >
Test Call Table).
2. Click Add; the following dialog box appears:
3. Configure a test call according to the parameters described in the table below.
4. Click Submit, and then save ("burn") your settings to flash memory.
Parameter
General Tab
Endpoint URI
CLI: endpoint-uri
[Test_Call_EndpointURI]
Called URI
CLI: called-uri
[Test_Call_CalledURI]
User's Manual
Figure 62-1: General Tab of Test Call Table
Table 62-1: Test Call Table Parameter Descriptions
Defines the endpoint's URI. This can be defined as a user or
user@host. The device identifies this endpoint only by the URI's
user part. The URI's host part is used in the SIP From header in
REGISTER requests.
The valid value is a string of up to 150 characters. By default, this
parameter is not configured.
Defines the destination (called) URI (user@host).
The valid value is a string of up to 150 characters. By default, this
parameter is not configured.
Description
740
Mediant 800B MSBR
Document #: LTRT-12813