AudioCodes Mediant 800B MSBR User Manual page 853

Mediant 800B MSBR
Parameter
Web: Attenuation Intensity
CLI: acoustic-echo-suppressor-
attenuation-intensity
[AcousticEchoSuppAttenuationIntensity]
Web: Max ERL Threshold - DB
CLI: acoustic-echo-suppressor-max-
ERL
[AcousticEchoSuppMaxERLThreshold]
Web: Min Reference Delay x10 msec
CLI: acoustic-echo-suppressor-min-
reference-delay
[AcousticEchoSuppMinRefDelayx10ms]
Web: Max Reference Delay x10 msec
CLI: acoustic-echo-suppressor-max-
reference-delay
[AcousticEchoSuppMaxRefDelayx10ms]
EMS: Echo Canceller Hybrid Loss
CLI: echo-canceller-hybrid-loss
[ECHybridLoss]
EMS: ECN lp Mode
CLI: echo-canceller-NLP-mode
[ECNLPMode]
CLI: echo-canceller-aggressive-NLP
[EchoCancellerAggressiveNLP]
CLI: number-of-SID-coefficients
[RTPSIDCoeffNum]
Answer Detector (AD) Parameters
Web: Enable Answer Detector
[EnableAnswerDetector]
Web: Answer Detector Activity Delay
CLI: answer-detector-activativity-delay
[AnswerDetectorActivityDelay]
Version 6.8
67. Configuration Parameters Reference
Defines the acoustic echo suppressor signals identified as
echo attenuation intensity.
The valid range is 0 to 3. The default is 0.
Defines the acoustic echo suppressor maximum ratio
between signal level and returned echo from the phone (in
decibels).
The valid range is 0 to 60. The default is 10.
Defines the acoustic echo suppressor minimum reference
delay (in 10-ms units).
The valid range is 0 to 40. The default is 0.
Defines the acoustic echo suppressor maximum reference
delay (in 10-ms units).
The valid range is 0 to 40. The default is 40 (i.e., 40 x 10 =
400 ms).
Defines the four-wire to two-wire worst-case Hybrid loss,
the ratio between the signal level sent to the hybrid and the
echo level returning from the hybrid.

[0] = (Default) 6 dB

[1] = N/A

[2] = 0 dB

[3] = 3 dB
Defines the echo cancellation Non-Linear Processing
(NLP) mode.

[0] = (Default) NLP adapts according to echo changes

[1] = Disables NLP

[2] = Silence output NLP
Note: This parameter can also be configured in a Tel
Profile.
Enables the Aggressive NLP at the first 0.5 second of the
call.

[0] = Disable

[1] = (Default) Enable. The echo is removed only in the
first half of a second of the incoming IP signal.
Note: For this parameter to take effect, a device reset is
required.
Defines the number of spectral coefficients added to an
SID packet being sent according to RFC 3389.
The valid values are [0] (default), [4], [6], [8] and [10].
Currently, not supported.
Defines the time (in 100-msec resolution) between
activating the Answer Detector and the time that the
detector actually starts to operate.
853
Description
Mediant 800B MSBR