AudioCodes Mediant 800B MSBR User Manual page 844

Parameter
[RTPOnlyModeForTrunk_x]
Web/EMS: Media IP Version
Preference
CLI: media-ip-ver-pref
[MediaIPVersionPreference]
Web/EMS: SIT Q850 Cause
[SITQ850Cause]
Web/EMS: SIT Q850 Cause
For NC
[SITQ850CauseForNC]
Web/EMS: SIT Q850 Cause
For IC
[SITQ850CauseForIC]
Web/EMS: SIT Q850 Cause
For VC
[SITQ850CauseForVC]
Web/EMS: SIT Q850 Cause
User's Manual

Configure E1/T1 Transparent protocol type (set the
ProtocoType parameter to 5 or 6).

Enable the TDM-over-IP feature (set the EnableTDMoverIP
parameter to 1).

To configure the RTP Only mode per trunk, use the
RTPOnlyModeForTrunk_x parameter.

If per trunk configuration (using the RTPOnlyModeForTrunk_ID
parameter) is set to a value other than the default, the
RTPOnlyMode parameter value is ignored.
Enables the RTP Only feature per trunk. The x in the parameter name
denotes the trunk number, where 0 is Trunk 1. For a description of this
parameter, see the RTPOnlyMode parameter.
Note: For using the global parameter (i.e., setting the RTP Only
feature for all trunks), set this parameter to -1 (default).
Global parameter that defines the preferred RTP media IP addressing
version (IPv4 or IPv6) for outgoing SIP calls. You can also configure
this functionality per specific calls, using IP Profiles
(IpProfile_MediaIPVersionPreference). For a detailed description of
this parameter and for configuring this functionality in the IP Profile
table, see Configuring IP Profiles on page 314.
Defines the Q.850 cause value specified in the SIP Reason header
that is included in a 4xx response when a Special Information Tone
(SIT) is detected on an IP-to-Tel call.
The valid range is 0 to 127. The default is 34.
Note: For mapping specific SIT tones, you can use the
SITQ850CauseForNC, SITQ850CauseForIC, SITQ850CauseForVC,
and SITQ850CauseForRO parameters.
Defines the Q.850 cause value specified in the SIP Reason header
that is included in a 4xx response when SIT-NC (No Circuit Found
Special Information Tone) is detected from the Tel side for IP-to-Tel
calls.
The valid range is 0 to 127. The default is 34.
Notes:

When not configured (i.e., default), the SITQ850Cause parameter
is used.

This parameter is applicable only to FXO interfaces.
Defines the Q.850 cause value specified in the SIP Reason header
that is included in a 4xx response when SIT-IC (Operator Intercept
Special Information Tone) is detected from the Tel for IP-to-Tel calls.
The valid range is 0 to 127. The default is -1 (not configured).
Note: When not configured (i.e., default), the SITQ850Cause
parameter is used.
Defines the Q.850 cause value specified in the SIP Reason header
that is included in a 4xx response when SIT-VC (Vacant Circuit - non-
registered number Special Information Tone) is detected from the Tel
for IP-to-Tel calls.
The valid range is 0 to 127. The default is -1 (not configured).
Note: When not configured (i.e., default), the SITQ850Cause
parameter is used.
Defines the Q.850 cause value specified in the SIP Reason header
844
Mediant 800B MSBR
Description
Document #: LTRT-12813