AudioCodes Mediant 800B MSBR User Manual page 964

Parameter
Web: Default Destination Number
CLI: dflt-dest-nb
[DefaultNumber]
Web: Source IP Address Input
CLI: src-ip-addr-input
[SourceIPAddressInput]
Web: Use Source Number As Display
Name
EMS: Display Name
CLI: src-nb-as-disp-name
[UseSourceNumberAsDisplayName]
User's Manual

All channels and trunks configured without a Trunk Group
ID.
for all Trunk Groups channels that are configured without a
Trunk Group ID,.

[0] By Dest Phone Number

[1] Cyclic Ascending (default)

[2] Ascending

[3] Cyclic Descending

[4] Descending

[5] Dest Number + Cyclic Ascending.

[6] By Source Phone Number

[7] Trunk Cyclic Ascending

[8] Trunk & Channel Cyclic Ascending

[9] Ring to Hunt Group

[10] Select Trunk By Supplementary Service Table

[11] Dest Number + Ascending
For a detailed description of the parameter's options, see
''Configuring Hunt Group Settings'' on page 367.
Defines the default destination phone number, which is used
if the received message doesn't contain a called party
number and no phone number is configured in the Trunk
Group table (see Configuring the Trunk Group Table on
page 365). This parameter is used as a starting number for
the list of channels comprising all the device's Trunk Groups.
The default is 1000.
Determines which IP address the device uses to determine
the source of incoming INVITE messages for IP-to-Tel
routing.

[-1] = (Default) Auto Decision - if the IP-to-IP feature is
enabled, this parameter is automatically set to Layer 3
Source IP. If the IP-to-IP feature is disabled, this
parameter is automatically set to SIP Contact Header (1).

[0] SIP Contact Header = The IP address in the Contact
header of the incoming INVITE message is used.

[1] Layer 3 Source IP = The actual IP address (Layer 3)
from where the SIP packet was received is used.
Determines the use of Tel Source Number and Display
Name for Tel-to-IP calls.

[0] No = (Default) If a Tel Display Name is received, the
Tel Source Number is used as the IP Source Number
and the Tel Display Name is used as the IP Display
Name. If no Display Name is received from the Tel side,
the IP Display Name remains empty.

[1] Yes = If a Tel Display Name is received, the Tel
Source Number is used as the IP Source Number and
the Tel Display Name is used as the IP Display Name. If
no Display Name is received from the Tel side, the Tel
Source Number is used as the IP Source Number and
also as the IP Display Name.

[2] Overwrite = The Tel Source Number is used as the IP
Source Number and also as the IP Display Name (even if
964
Mediant 800B MSBR
Description
Document #: LTRT-12813