Ip Connectivity Parameters - AudioCodes Mediant 800B MSBR User Manual

Parameter
Web: Tel2IP Call Forking Mode
CLI: tel2ip-call-forking-mode
[Tel2IPCallForkingMode]
CLI: configure voip/sip-definition
advanced-settings/forking-delay-time-
invite
[ForkingDelayTimeForInvite]
67.10.13

IP Connectivity Parameters

The IP connectivity parameters are described in the table below.
Parameter
Web: Enable Alt Routing Tel to IP
EMS: Enable Alternative Routing
CLI: alt-routing-tel2ip
[AltRoutingTel2IPEnable]
Web: Alt Routing Tel to IP Mode
EMS: Alternative Routing Mode
CLI: alt-rte-tel2ip-mode
[AltRoutingTel2IPMode]
Web: Alt Routing Tel to IP
User's Manual
other words, for an INVITE message, the device can receive
up to 20 forking responses from the Proxy server.
The valid range is 0 to 30. The default is 30.
Enables Tel-to-IP call forking, whereby a Tel call can be
routed to multiple IP destinations.

[0] Disable (default)

[1] Enable
Note: Once enabled, routing rules must be assigned Forking
Groups in the Outbound IP Routing table.
Defines the interval (in seconds) to wait before sending
INVITE messages to the other members of the forking
group. The INVITE is immediately sent to the first member.
The valid value range is 0 to 40. The default is 0 (i.e., sends
immediately).
Table 67-70: IP Connectivity Parameters
Enables the Alternative Routing feature for Tel-to-IP calls.

[0] Disable = (Default) Disables the Alternative Routing
feature.

[1] Enable = Enables the Alternative Routing feature.

[2] Status Only = The Alternative Routing feature is
disabled, but read-only information on the QoS of the
destination IP addresses is provided.
Determines the IP Connectivity event(s) reason for triggering
Alternative Routing.

[0] None = Alternative routing is not used.

[1] Connectivity = Alternative routing is performed if SIP
OPTIONS message to the initial destination fails
(determined according to the AltRoutingTel2IPConnMethod
parameter).

[2] QoS = Alternative routing is performed if poor QoS is
detected.

[3] Both = (Default) Alternative routing is performed if either
SIP OPTIONS to initial destination fails, poor QoS is
detected, or the DNS host name is not resolved.
Notes:

QoS is quantified according to delay and packet loss
calculated according to previous calls. QoS statistics are
reset if no new data is received within two minutes.

To receive quality information (displayed in the 'Quality
Status' and 'Quality Info.' fields in ''Viewing IP Connectivity''
on page 687) per destination, this parameter must be set to
2 or 3.
Determines the method used by the device for periodically
970
Mediant 800B MSBR
Description
Description
Document #: LTRT-12813