Voice Mail Parameters - AudioCodes Mediant 800B MSBR User Manual

Parameter
Web: Inter Digit Timeout for
Overlap Dialing [sec]
EMS: Interdigit Timeout (Sec)
CLI: time-btwn-dial-digs
[TimeBetweenDigits]
Web: Enable Special Digits
EMS: Use '#' For Dial Termination
CLI: special-digits
[IsSpecialDigits]

67.10.4 Voice Mail Parameters

The voice mail parameters are described in the table below. For more information on the
Voice Mail application, refer to the CPE Configuration Guide for Voice Mail.
Parameter
Web/EMS: Voice Mail Interface
CLI: vm-interface
[VoiceMailInterface]
User's Manual
Notes:

Instead of using this parameter, Digit Mapping rules can be
configured.

For FXS/FXO interfaces: Dialing ends when any of the
following scenarios occur:

Maximum number of digits is dialed

Interdigit Timeout (TimeBetweenDigits) expires

Pound (#) key is pressed

Digit map pattern is matched
Analog: Defines the time (in seconds) that the device waits
between digits that are dialed by the user.
ISDN overlap dialing: Defines the time (in seconds) that the
device waits between digits that are received from the PSTN or
IP during overlap dialing.
When this inter-digit timeout expires, the device uses the
collected digits to dial the called destination number.
The valid range is 1 to 10. The default is 4.
Determines whether the asterisk (*) and pound (#) digits can be
used in DTMF.

[0] Disable = Use '*' or '#' to terminate number collection
(refer to the parameter UseDigitForSpecialDTMF). (Default.)

[1] Enable = Allows '*' and '#' for telephone numbers dialed
by a user or for the endpoint telephone number.
Notes:

The symbols can always be used as the first digit of a dialed
number even if you disable this parameter.

This parameter is applicable only to FXS and FXO
interfaces.
Table 67-44: Voice Mail Parameters
Enables the device's Voice Mail application and determines the
communication method between the device and PBX.

[0] None (default)

[1] DTMF

[2] SMDI

[3] QSIG

[4] SETUP Only = Applicable only to ISDN.

[5] MATRA/AASTRA QSIG

[6] QSIG SIEMENS = QSIG MWI activate and deactivate
messages include Siemens Manufacturer Specific Information
(MSI)

[7] IP2IP = The device's IP-to-IP application is used for
interworking between an IP Voice Mail server and the device.
874
Mediant 800B MSBR
Description
Description
Document #: LTRT-12813