AudioCodes Mediant 800B MSBR User Manual page 939

Multi-service business router; session border controller
Hide thumbs Also See for Mediant 800B MSBR:
Table of Contents

Advertisement

Mediant 800B MSBR
Parameter
CLI: isdn-xfer-cab
[ISDNTransferCapability_x]
[TransferCapabilityForDataC
alls]
Web: ISDN Transfer On
Connect
EMS: Send ISDN Transfer On
Connect
CLI: isdn-trsfr-on-conn
[SendISDNTransferOnConne
ct]
[ISDNTransferCompleteTime
out]
Web/EMS: Enable Network
ISDN Transfer
CLI: network-isdn-xfer
[EnableNetworkISDNTransfer
]
[DisableFallbackTransferToT
DM]
Web: Enable QSIG Transfer
Version 6.8
[0] Audio 3.1 (default)
[1] Speech
[2] Data
Notes:
If this parameter is not configured or is set to -1, Audio 3.1
capability is used.
The Audio 7 option is currently not supported.
The x in the ini file parameter name denotes the trunk number,
where 0 is Trunk 1.
Defines the ISDN Transfer Capability for data calls.
[0] = (Default) ISDN Transfer Capability for data calls is 64k
unrestricted (data).
[1] = ISDN Transfer Capability for data calls is determined
according to the ISDNTransferCapability parameter.
This parameter is used for the ECT/TBCT/RLT/Path Replacement
ISDN transfer methods. Usually, the device requests the PBX to
connect an incoming and outgoing call. This parameter determines
if the outgoing call (from the device to the PBX) must be connected
before the transfer is initiated.
[0] Alert = (Default) Enables ISDN Transfer if the outgoing call is
in Alerting or Connect state.
[1] Connect = Enables ISDN Transfer only if the outgoing call is
in Connect state.
Note: For RLT ISDN transfer (TrunkTransferMode = 2 and
ProtocolType = 14 DMS-100), this parameter must be set to 1.
Defines the timeout (in seconds) for determining ISDN call transfer
(ECT, RLT, or TBCT) failure. If the device does not receive any
response to an ISDN transfer attempt within this user-defined time,
the device identifies this as an ISDN transfer failure and
subsequently performs a hairpin TDM connection or sends a SIP
NOTIFY message with a SIP 603 response (depending whether
hairpin is enabled or disabled, using the parameter
DisableFallbackTransferToTDM).
The valid range is 1 to 10. The default is 4.
Determines whether the device allows interworking of network-side
received ECT/TBCT Facility messages (NI-2 TBCT - Two B-
channel Transfer and ETSI ECT - Explicit Call Transfer) to SIP
REFER.
[0] Disable = Rejects ISDN transfer requests.
[1] Enable = (Default) The device sends a SIP REFER message
to the remote call party if ECT/TBCT Facility messages are
received from the ISDN side (e.g., from a PBX).
Enables "hairpin" TDM transfer upon ISDN (ECT, RLT, or TBCT)
call transfer failure. When this feature is enabled and an ISDN call
transfer failure occurs, the device sends a SIP NOTIFY message
with a SIP 603 Decline response.
[0] = (Default) The device performs a hairpin TDM transfer upon
ISDN call transfer.
[1] = Hairpin TDM transfer is disabled.
Determines whether the device interworks QSIG Facility messages
939
67. Configuration Parameters Reference
Description
Mediant 800B MSBR

Advertisement

Table of Contents
loading

Table of Contents