Crp Configuration; Enabling The Crp Application - AudioCodes Mediant 800B MSBR User Manual

Mediant 800B MSBR
40

CRP Configuration

This section describes configuration specific to the CRP application. As CRP has similar
functionality to the SBC application, for configuration that is common to the SBC, which is
not covered in this section, see the following SBC sections:

''Configuring General Settings'' on page 535

''Configuring Admission Control'' on page 539

''Configuring Allowed Audio Coder Groups'' on page 543

''Configuring Classification Rules'' on page 545

''Configuring Message Condition Rules'' on page 551

''Configuring SBC IP-to-IP Routing Rules'' on page 552

''Configuring SIP Response Codes for Alternative Routing Reasons'' on page 561

''Configuring IP-to-IP Inbound Manipulations'' on page 565

''Configuring IP-to-IP Outbound Manipulations'' on page 568
Note:
applications is the navigation menu paths to opening these Web configuration pages.
Wherever "SBC" appears in the menu path, for the CRP application it appears as
"CRP".
40.1

Enabling the CRP Application

Before you can start configuring the CRP, you must first enable the CRP application. Once
enabled, the Web interface displays the menus and parameter fields relevant to the CRP
application.
Note:
License Key that includes this feature. For installing a Software License Key, see
''Software License Key'' on page 621.

To enable the CRP application:
1. Open the Applications Enabling page (Configuration tab > VoIP menu >
Applications Enabling > Applications Enabling).
2. From the 'CRP Application' drop-down list, select Enable.
3. Click Submit, and then reset the device with a burn-to-flash for your settings to take
effect.
Version 6.8
The main difference in the common configuration between the CRP and SBC
The CRP feature is available only if the device is installed with a Software
577
40. CRP Configuration
Mediant 800B MSBR