AudioCodes Mediant 800B MSBR User Manual page 743

Mediant 800B MSBR
Parameter
Test Mode
CLI: test-mode
[Test_Call_TestMode]
Test Duration
CLI: test-duration
[Test_Call_TestDuration]
Play
CLI: play
[Test_Call_Play]
Schedule Interval
CLI: schedule-interval
[Test_Call_ScheduleInterval]
Version 6.8
Defines the test session mode.

[0] Once = (Default) The test runs until the lowest value
between the following is reached:

Maximum channels is reached for the test session,
configured by 'Maximum Channels for Session'.

Call duration ('Call Duration') multiplied by calls per
second ('Calls per Second').

Test duration expires, configured by 'Test Duration'.

[1] Continuous = The test runs until the configured test
duration is reached. If it reaches the maximum channels
configured for the test session (in the 'Maximum Channels for
Session'), it waits until the configured call duration of a
currently established tested call expires before making the next
test call. In this way, the test session stays within the
configured maximum channels.
Note: This parameter is applicable only if 'Call Party' is set to
Caller.
Defines the test duration (in minutes).
The valid value is 0 to 100000. The default is 0 (i.e., unlimited).
Note: This parameter is applicable only if 'Call Party' is set to
Caller.
Enables and defines the playing of a tone to the answered side of
the call.

[0] Disable

[1] DTMF (default) = Plays a user-defined DTMF string,
configured in ''Configuring DTMF Tones for Test Calls'' on
page 746.

[2] PRT = Plays a non-DTMF tone from the PRT file (Dial Tone
2). For this option, a PRT file must be loaded to the device
(see ''Prerecorded Tones File'' on page 604).
Notes:

To configure the DTMF signaling type (e.g., out-of-band or in-
band) use the 'DTMF Transport Type' parameter (see
''Configuring DTMF Transport Types'' on page 192).

This parameter is applicable only if 'Call Party' is set to Caller.
Defines the interval (in minutes) between automatic outgoing test
calls.
The valid value range is 0 to 100000. The default is 0 (i.e.,
scheduling is disabled).
Note: This parameter is applicable only if 'Call Party' is set to
Caller.
743
62. Testing SIP Signaling Calls
Description
Mediant 800B MSBR