AudioCodes Mediant 800B MSBR User Manual page 369

Mediant 800B MSBR
Parameter
Registration Mode
CLI: registration-mode
[TrunkGroupSettings_Registration
Mode]
Version 6.8

For the second incoming call, the first channel of
Trunk 1 is selected.

For the third incoming call, the second channel of
Trunk 0 is selected.

[9] Ring to Hunt Group = The device allocates IP-to-Tel
calls to all the FXS ports (channels) in the Hunt Group.
When a call is received for the Hunt Group, all telephones
connected to the FXS ports belonging to the Hunt Group
start ringing. The call is eventually received by whichever
telephone first answers the call (after which the other
phones stop ringing). This option is applicable only to
FXS interfaces.

[10] Select Trunk by Supplementary Services Table =
The BRI port/module is selected according to the settings
in the ISDN Supplementary Services table (see
Configuring Multi-Line Extensions and Supplementary
Services on page 465), allowing the routing of IP-to-Tel
calls to specific BRI endpoints according to extension
number. This option is applicable only to FXS and BRI
interfaces.

[11] Dest Number + Ascending = The device allocates a
channels to incoming IP-to-Tel calls as follows:
a. The device attempts to route the call to the channel
that is associated with the destination (called)
number. If located, the call is sent to that channel.
b. If the number is not located or the channel is
unavailable (e.g., busy), the device searches in
ascending order for the next available channel in the
Trunk Group. If located, the call is sent to that
channel.
c. If all the channels are unavailable, the call is
released.
Note: If this parameter is not configured, the Trunk Group's
channel select method is according to the global parameter,
ChannelSelectMode.
Defines the registration method for the Trunk Group:

[1] Per Gateway = (Default) Single registration for the
entire device. This is applicable only if a default Proxy or
Registrar IP is configured and Registration is enabled
(i.e., parameter IsRegisterUsed is set to 1). In this mode,
the SIP URI user part in the From, To, and Contact
headers is set to the value of the global registration
parameter, GWRegistrationName or username if
GWRegistrationName is not configured.

[0] Per Endpoint = Each channel in the Trunk Group
registers individually. The registrations are sent to the
'Serving IP Group ID' if defined in the table, otherwise, it
is sent to the default Proxy, and if no default Proxy, then
to the Registrar IP.

[4] Don't Register = No registrations are sent by
endpoints pertaining to the Trunk Group. For example, if
the device is configured globally to register all its
endpoints (using the parameter ChannelSelectMode),
you can exclude some endpoints from being registered
369
26. Trunk Group
Description
Mediant 800B MSBR