Configuring Automatic Dialing - AudioCodes Mediant 800B MSBR User Manual

Parameter
[Authentication_Index]
Port
CLI: port
[Authentication_Port]
Module
CLI: port-type
[Authentication_Module]
Port Type
[Authentication_PortType]
User Name
CLI: user-name
[Authentication_UserId]
Password
CLI: password
[Authentication_UserPassword]
31.5

Configuring Automatic Dialing

The Automatic Dialing table lets you configure telephone numbers that are automatically
dialed when FXS or FXO ports go off-hook. The dialing can be done immediately upon off-
hook, or after a user-defined interval after off-hook referred to as Hotline dialing.
The following procedure describes how to configure automatic dialing upon off-hook in the
Web interface. You can also configure this using the table ini file parameter,
TargetOfChannel or CLI command, configure voip > gw analoggw automatic-dialing.

To configure automatic dialing per port:
1. Open the Automatic Dialing page (Configuration tab > VoIP menu > GW and IP to IP
> Analog Gateway > Automatic Dialing).
2. Click Add; the following dialog box appears:
The figure above shows a configuration example where hotline-automatic dialing is
enabled for an FXS port, whereby if the port is off-hooked for over 15 seconds, the
device automatically dials 911.
3. Configure automatic dialing per port according to the parameters described in the
table below.
4. Click Submit, and then save ("burn") your settings to flash memory.
User's Manual
(Read-only) Displays the port number.
(Read-only) Displays the module number on which the port is
located.
(Read-only) Displays the port type (FXS or FXO).
Defines the user name used for authenticating the port.
Defines the password used for authenticating the port.
478
Mediant 800B MSBR
Description
Document #: LTRT-12813