AudioCodes Mediant 800B MSBR User Manual page 152

2. Click Add; the following dialog box appears:
3. Configure a NAT translation rule according to the parameters described in the table
below.
4. Click Submit, and then save ("burn") your settings to flash memory.
Table 16-17: NAT Translation Table Parameter Descriptions
Parameter
Index
CLI: index
[NATTranslation_Index]
Source Interface Name
CLI: SourceIPInterfaceName
[NATTranslation_SourceIPInterfaceName]
Target IP Address
CLI: TargetIPAddress
[NATTranslation_TargetIPAddress]
Source Start Port
CLI: SourceStartPort
[NATTranslation_SourceStartPort]
Source End Port
CLI: SourceEndPort
[NATTranslation_SourceEndPort]
Target Start Port
CLI: TargetStartPort
[NATTranslation_TargetStartPort]
User's Manual
Figure 16-12: NAT Translation Table Page
Defines an index number for the new table record.
Note: Each table row must be configured with a
unique index.
Defines the name of the IP interface, as configured in
the Interface table.
Defines the global IP address. This address is set in
the SIP Via and Contact headers as well as in the o=
and c= SDP fields.
Defines the optional starting port range (1-65536) of
the IP interface, used as matching criteria for this NAT
rule. If not configured, the match is done on the entire
port range. Only IP addresses and ports of matched
source ports will be replaced.
Defines the optional ending port range (1-65536) of
the IP interface, used as matching criteria for this NAT
rule. If not configured, the match is done on the entire
port range. Only IP addresses and ports of matched
source ports will be replaced.
Defines the optional, starting port range (1-65536) of
the global address. If not configured, the ports are not
replaced. Matching source ports are replaced with the
target ports. This address is set in the SIP Via and
Contact headers, as well as in the o= and c= SDP
fields.
152
Mediant 800B MSBR
Description
Document #: LTRT-12813