Configuring Radius Accounting - AudioCodes Mediant 800B MSBR User Manual

55.3

Configuring RADIUS Accounting

The device can send accounting data of SIP calls as call detail records (CDR) to a RADIUS
Accounting server. The device can send the accounting messages to the RADIUS server
upon call release, call connection and release, or call setup and release. For a list of the
CDR attributes, see the table following the procedure below.

To configure RADIUS accounting:
1. Open the RADIUS Parameters page (Configuration tab > VoIP menu > SIP
Definitions > RADIUS Parameters Settings).
2. Set the 'Enable RADIUS Access Control' parameter to Enable.
3. Configure the remaining parameters as required. For a description of these
parameters, see ''RADIUS Parameters'' on page 1007.
4. Click Submit.
5. For your settings to take effect, reset the device with a flash burn.
The table below lists the RADIUS Accounting CDR attributes included in the
communication packets transmitted between the device and a RADIUS server.
Table 55-5: Supported RADIUS Accounting CDR Attributes
Attribute Attribute
Number Name
Request Attributes
1 user-name
4 nas-ip-
address
6 service-type
26 h323-
incoming-
conf-id
26 h323-remote-
address
26 h323-conf-id
26 h323-setup-
User's Manual
Figure 55-3: RADIUS Accounting Parameters Page
Vendor
Specific
Purpose
Attribute
(VSA) No.
- Account number or
calling party number
or blank
- IP address of the
requesting device
- Type of service
requested
1 SIP call identifier
23 IP address of the
remote gateway
24 H.323/SIP call
identifier
25 Setup time in NTP
Value
Format
String
up to 15
digits
long
Numeric 192.168.14.43
Numeric 1: login
Up to 32
octets
Numeric -
Up to 32
octets
String
704
Mediant 800B MSBR
Example AAA
5421385747 Start Acc
Stop Acc
Start Acc
Stop Acc
Start Acc
Stop Acc
- Start Acc
Stop Acc
Stop Acc
- Start Acc
Stop Acc
- Start Acc
Document #: LTRT-12813