AudioCodes Mediant 800B MSBR User Manual page 924

Parameter
interface bri <module/port>)
[BriTEIConfigP2P_x]
CLI: tei-config-p2mp (config-voice >
interface bri <module/port>)
[BriTEIConfigP2MP_x]
CLI: tei-assign-trigger (config-voice >
interface bri <module/port>)
[BriTEIAssignTrigger_x]
CLI: tei-remove-trigger (config-voice >
interface bri <module/port>)
[BriTEIRemoveTrigger_x]
NFAS Parameters
(Note: These parameters are applicable only to PRI interfaces.)
Web: NFAS Group Number
EMS: Group Number
CLI: isdn-nfas-group-number
[NFASGroupNumber_x]
User's Manual
point-to-point (P2P) mode.
The valid value is 0 to 63, 127. The default is 0.

Network Side:

0-63: Static TEI is accepted.

127: Any possible TEI is accepted. Dynamic TEI
allocation is supported.

User Side:

0-63: Static TEI is used.

127: Dynamic TEI allocation is supported (TEI
request procedure initiated).
Note: The value 127 replaces the previous configuration
requirement to set the ISDNIBehavior parameter to NS
EXPLICIT INTERFACE ID (1).
Defines the BRI TEI when in point-to-multipoint (P2MP)
mode.
The valid value is 0 to 63, 127. The default is 127.

Network Side: Not applicable - In network side in P2MP
configuration, any TEI must be accepted.

User Side:

0-63: Static TEI is used.

127: Dynamic TEI allocation is supported (TEI
request procedure initiated).
Defines when to start the TEI assignment procedure.
The valid values are (bit-field parameter):

Bit#0: LAYER1_ACTIVATION

Bit#1: BRI_PORT_CONFIG

Bit#2: CALL_ESTABLISH
The default is 0x02.
Note: The parameter is applicable only to the User side (for
Dynamic TEI).
Defines the following:

Network Side: When to "forget" all existing TEIs and wait
for the User side to start a new TEI assignment
procedure. This is also applicable to static TEI.

User Side: When to start a new TEI assignment
verification procedure.
The valid values are (bit-field parameter):

Bit#0: LAYER1_DEACTIVATION

Bit#1: BRI_DL_RELEASED

Bit#2: TEI_0_P2MP_NET_SIDE
The default is 0x00.
Defines the ISDN Non-Facility Associated Signaling (NFAS)
group number (NFAS member), per trunk.

[0] = (Default) Non-NFAS trunk.

[1] to [12] = NFAS group number.
Trunks that belong to the same NFAS group have the same
924
Mediant 800B MSBR
Description
Document #: LTRT-12813