Quality Of Experience Parameters - AudioCodes Mediant 800B MSBR User Manual

Mediant 800B MSBR
Parameter
CLI: enable
[OCSPEnable]
Web: Primary Server IP
EMS: OCSP Server IP
CLI: server-ip
[OCSPServerIP]
Web: Secondary Server IP
CLI: secondary-server-ip
[OCSPSecondaryServerIP]
Web: Server Port
EMS: OCSP Server Port
CLI: server-port
[OCSPServerPort]
Web: Default Response When
Server Unreachable
EMS: OCSP Default
Response
CLI: default-response
[OCSPDefaultResponse]
67.5

Quality of Experience Parameters

The Quality of Experience (QoE) parameters are described in the table below.
Parameter
SEM Parameters
Web: Server IP
CLI: configure voip/qoe
configuration/server-ip
[QOEServerIP]
Web: Redundant Server IP
CLI: configure voip > qoe
configuration > set
secondary-server-ip
[QOESecondaryServerIp]
Web: Port
CLI: configure voip/qoe
configuration/port
[QOEPort]
Web: Interface Name
CLI: configure voip/qoe
configuration/interface-name
[QOEInterfaceName]
Quality of Experience Profile Table
Version 6.8

[1] Enable
For a description of OCSP, see Configuring Certificate Revocation
Checking (OCSP).
Defines the IP address of the OCSP server.
The default IP address is 0.0.0.0.
Defines the IP address (in dotted-decimal notation) of the secondary
OCSP server (optional).
The default IP address is 0.0.0.0.
Defines the OCSP server's TCP port number.
The default port number is 2560.
Determines whether the device allows or rejects peer certificates
when the OCSP server cannot be contacted.

[0] Reject (default)

[1] Allow
Table 67-32: Quality of Experience Parameters
Defines the IP address of the primary Session Experience Manager
(SEM) server to where the quality experience reports are sent.
Note: For this parameter to take effect, a device reset is required.
Defines the IP address of the secondary SEM server to where the
quality experience reports are sent. This is applicable when the
SEM/EMS server is in Geographical Redundancy HA mode.
Note: For this parameter to take effect, a device reset is required.
Defines the port of the SEM server.
The valid value range is 0 to 65534. The default is 5000.
Defines the IP network interface on which the quality experience
reports are sent.
The default is the OAMP interface.
Note: For this parameter to take effect, a device reset is required.
67. Configuration Parameters Reference
Description
Description
805 Mediant 800B MSBR