Table of Contents
Advertisement
8.2
Machine OPR
8.2.1
Outline of the machine OPR operation
Use the OPR retry function when the OP position is not always in the same direction from the workpiece operation area
(when the OP is not set near the upper or lower limit of the machine).
The machine OPR may not complete unless the OPR retry function is used.
(1) Machine OPR operation
In a machine OPR, a machine OP is established.
None of the address information stored in the LD75, CPU module, or servo is used at this time.
The position mechanically established after the machine OPR is regarded as the "OP" to be the starting point for
positioning control.
The method for establishing an "OP" by a machine OPR differs according to the method set in "[Pr.43] OPR
method".
The following shows the operation when starting a machine OPR.
1.
The machine OPR is started.
2.
The operation starts according to the speed and direction set in the OPR parameters ([Pr.43] to
[Pr.57]).
3.
The "OP" is established by the method set in "[Pr.43] OPR method", and the machine stops. (
Page 319, Section 8.2.2 to Page 335, Section 8.2.8)
4.
If "a" is set as "[Pr.45] OP address", "a" will be stored as the current position in the "[Md.20]
Current feed value" and "[Md.21] Machine feed value" which are monitoring the position.
5.
The machine OPR is completed.
The "[Pr.45] OP address" is a fixed value set by the user.
318
M
OP
Near-point dog
Machine OPR
Advertisement
Table of Contents
Troubleshooting
