Mitsubishi Electric MELSEC-L LD75P User Manual page 277

CHAPTER 6 PROGRAM USED FOR POSITIONING CONTROL
(3) Program example
An example of the "Axis 1" positioning program is given in this section.
[No.1] to [No.3] parameter and data setting program
• When setting the parameters or data with the program, set them in the LD75 using the TO instruction from the CPU module. (Carry out the settings while the
PLC READY signal [Y0] is OFF.)
• When setting the parameters or data with GX Works2, the [No.1] to [No.3] program is not necessary.
6
275