Mitsubishi Electric MELSEC-L LD75P User Manual page 759

3.
Select the function.
Select "Positioning start signal" from the pull-down menu of "Select Function".
4.
Perform positioning start test.
• Select "Positioning Start Signal", "Block Start", or "Multiple Axes Simultaneous Start" for "Start Type".
• Set positioning start data according to the setting for "Start Type".
Positioning Start Signal:
Set the positioning data No.
Block Start:
Set the block No. and point No.
Multiple Axes Simultaneous Start:
Set the multiple axes simultaneous start data No.
Set "Step" and "External Command" as needed.
Step:
To perform test operation by step start, check the "Start step" checkbox, select a step mode from the
pull-down list, and click the [Continue] button.
External Command:
To enable external commands or control switch, select the corresponding item and click the [Set]
button.
• Click the [Starting] button to perform test operation.
APPENDICES
A
757