Positioning Program Examples; When Using The Ld75 In A Standard System Configuration - Mitsubishi Electric MELSEC-L LD75P User Manual

6.4

Positioning Program Examples

6.4.1

When using the LD75 in a standard system configuration

(1) Program example
An example of the "Axis 1" positioning program is given in this section.
• When setting the parameters or data with the program, set them in the LD75 using the TO instruction from the CPU module. (Carry out the settings while the
PLC READY signal [Y0] is OFF.)
• When setting the parameters or data with GX Works2, the [No.1] to [No.3] program is not necessary.
CHAPTER 6 PROGRAM USED FOR POSITIONING CONTROL
[No.1] to [No.3] parameter and data setting program
6
261