Appendix 6.2 Parameter Setting - Mitsubishi Electric MELSEC-L LD75P User Manual

Positioning module
Hide thumbs Also See for MELSEC-L LD75P:
Table of Contents

Advertisement

Appendix 6.2
Set parameters for the positioning module.
By setting parameters, the parameter setting by program is not needed.
(1) Parameter setting
(a) Operating procedure
1.
Open the "Parameter" window.
Project window  [Intelligent Function Module]  Module name  "Parameter"
2.
Configure settings.
Double-click the setting-target item and select or enter a value.
• Items with a pull-down list
Double-click the item and select an item in the displayed pull-down list.
• Items without a pull-down list
Double-click the item and enter a value.
For details on the setting items, refer to the following.
Basic parameters 1
Basic parameters 2
Detailed parameters 1
Detailed parameters 2
OPR basic parameters
OPR detailed parameters
Parameter setting
Item
Reference
Page 118, Section 5.2.1
Page 125, Section 5.2.2
Page 126, Section 5.2.3
Page 133, Section 5.2.4
Page 140, Section 5.2.5
Page 148, Section 5.2.6
APPENDICES
A
739

Advertisement

Table of Contents
loading

This manual is also suitable for:

Melsec-l ld75d

Table of Contents