Table of Contents
Advertisement
[Pr.25]
[Pr.26]
[Pr.27]
[Pr.28]
[Pr.29]
[Pr.30]
[Pr.31]
[Pr.32]
[Pr.33]
Detailed parameters 2
[Pr.34]
[Pr.35]
[Pr.36]
[Pr.37]
[Pr.38]
[Pr.39]
[Pr.40]
[Pr.41]
[Pr.42]
*1
This is an irrelevant item, so the set value will be ignored. If the value is the default value or within the setting range,
there is no problem.
Positioning parameter
Acceleration time 1
Acceleration time 2
Acceleration time 3
Deceleration time 1
Deceleration time 2
Deceleration time 3
JOG speed limit value
JOG operation acceleration time selection
JOG operation deceleration time selection
Acceleration/deceleration process selection
S-curve ratio
Sudden stop deceleration time
Stop group 1 sudden stop selection
Stop group 2 sudden stop selection
Stop group 3 sudden stop selection
Positioning complete signal output time
Allowable circular interpolation error width
External command function selection
CHAPTER 5 DATA USED FOR POSITIONING CONTROL
OPR control
97
5
Advertisement
Table of Contents
Troubleshooting
