Mitsubishi Electric MELSEC-L LD75P User Manual page 420

(4) Positioning data setting example
The following table shows the setting examples when "1-axis speed control (forward run: speed 1)" is set in the
positioning data No. 1 of axis 1.
Setting item
[Da.1]
[Da.2]
[Da.3]
[Da.4]
[Da.5]
Axis 1
positioning
data No. 1
[Da.6]
[Da.7]
[Da.8]
[Da.9]
[Da.10]
Refer to  Page 152, Section 5.3 for information on the setting details.
418
Setting example
Operation pattern Positioning complete
Control system Forward run speed 1
Acceleration time No.
Deceleration time No.
Axis to be interpolated
Positioning
address/movement
amount
Arc address
Command speed 6000.00mm/min
Dwell time
M code
Setting other than "Positioning complete" is not possible in speed
control.
Set 1-axis speed control.
Designate the value set in "[Pr.25] Acceleration time 1" as the
1
acceleration time at start.
Designate the value set in "[Pr.10] Deceleration time 0" as the
0
deceleration time at deceleration.

Setting not required. (Setting value will be ignored.)
 Setting not required. (Setting value will be ignored.)

Setting not required. (Setting value will be ignored.)
Set the speed to be commanded.

Setting not required. (Setting value will be ignored.)
Set this when other sub operation commands are issued in combination
10 with the No. 1 positioning data. ("[Pr.18] M code ON signal output timing"
setting only possible in the WITH mode.)
Setting details