Mitsubishi Electric MELSEC-L LD75P User Manual page 380

Positioning module

Hide thumbs Also See for MELSEC-L LD75P:

Table of Contents

● When the "reference axis speed" is set during 4-axis linear interpolation control, set so the major axis side becomes the

reference axis. If the minor axis side is set as the reference axis, the major axis side speed may exceed the "[Pr.8] Speed

limit value".

● Refer to  Page 359, Section 9.1.6 for the combination of the reference axis with the interpolation axis.

Troubleshooting

Melsec-l ld75d