Mitsubishi Electric MELSEC-L LD75P User Manual page 180

Remark
To perform an high-level positioning control using block start data, set a number between 7000 and 7004 to the "[Cd.3]
Positioning start No." and use the "[Da.4] Positioning starting point No." to specify a point number between 1 and 50, a
position counted from the beginning of the block.
The number between 7000 and 7004 specified here is called the "block No.".
With the LD75, up to 50 "block start data" points and up to 10 "condition data" items can be assigned to each "block No.".
*2
Block No.
7000
7001
7002
7003
7004
*2 Setting cannot be made when the "Pre-reading start function" is used. If any of Nos.7000 to 7004 is set and the Pre-
reading start function is performed, the error "Outside start No. range" (error code: 543) will occur. (For details, refer to
 Page 598, Section 12.7.7.)
178
Axis Block start data
Axis 1
Axis 2
Start block 0
Axis 3
Axis 4
Axis 1
Axis 2
Start block 1
Axis 3
Axis 4
Axis 1
Axis 2
Start block 2
Axis 3
Axis 4
Axis 1
Axis 2
Start block 3
Axis 3
Axis 4
Axis 1
Axis 2
Start block 4
Axis 3
Axis 4
Condition Buffer memory
Condition data (1 to 10)
Condition data (1 to 10)
Condition data (1 to 10)
Condition data (1 to 10)
Condition data (1 to 10)
Condition data (1 to 10)
Condition data (1 to 10)
Condition data (1 to 10)
Condition data (1 to 10)
Condition data (1 to 10)
Condition data (1 to 10)
Condition data (1 to 10)
Condition data (1 to 10)
Condition data (1 to 10)
Condition data (1 to 10)
Condition data (1 to 10)
Condition data (1 to 10)
Condition data (1 to 10)
Condition data (1 to 10)
Condition data (1 to 10)
GX Works2
Supports the Supports the
settings settings