Mitsubishi Electric MELSEC-L LD75P User Manual page 417

Positioning module
Hide thumbs Also See for MELSEC-L LD75P:
Table of Contents

Advertisement

CHAPTER 9 MAJOR POSITIONING CONTROL
9
Set a value in "[Da.8] Command speed" so that the speed of each axis does not exceed the "[Pr.8] Speed limit value". (The
speed limit does not function for the speed calculated by the LD75 during interpolation control.)
415

Advertisement

Table of Contents
loading

This manual is also suitable for:

Melsec-l ld75d

Table of Contents