Menu Overview; Table 2-6. Menu Overview - Teledyne T400 User Manual

2.4

MENU OVERVIEW

Table 2-8 describes the main menus and provides cross-references to the respective
sections with configuration details.
Table 2-8. Menu Overview
MENU
View and plot concentration readings and other selectable parameter
Home values (Figure 2-26).
View user-selected parameters and their values, some of which can be
Dashboard
displayed in a live-plot graph (Figure 2-27).
View and clear active Alerts that were triggered by factory-defined
Alerts
Events as well as user-defined Events. (Active and past Alerts are
recorded in the Utilities>Alerts Log).
Run a multipoint calibration on the gas (or additional gas if 2
Calibration
option installed), and span and zero calibrations (if valve option
installed).
View logs, download data and firmware updates, copy configurations
Utilities
between instruments, and run diagnostics.
Configure a variety of features and functions through these submenus for
Setup
customized operation.
Datalogging
Events
Dashboard
Auto Cal
(with valve options)
Vars
Homescreen Select up to three parameters to be displayed in the meters
Digital
Outputs
Analog
Outputs
Instrument
Comm
52
DESCRIPTION
Track and record concentration and calibration data and
selectable diagnostic parameters, the reports for which can
be viewed in the Utilities>Datalog View menu (Section 2.4.5)
and downloaded to a flash drive via the Utilities>USB Utilities
menu (Section 2.4.5).
Also, select configured Events (Section 2.5.2) and create
customized triggers for data logging functions.
Select parameters and define the conditions by which they
are to be flagged and recorded in the Alerts log
(Section 2.4.3) when they are triggered. Once configured,
Events can be used to trigger Datalogs. (Section 2.5.1). Note
that some Events are predefined and are not editable.
Monitor instrument functionality (Figure 2-24) via selectable
parameters.
When zero/span valve options installed, configure
sequences for automatic calibration functions.
Manually adjust several software variables that define
specific operational parameters.
(Figure 2-25).
Map the rear-panel digital outputs to a variety of signals
present in the instrument to monitor the status of operating
conditions or custom Events.
Send user-selected parameter readings in the form of user-
defined voltage or current loop signals as outputs to a strip
chart recorder and/or the data logger.
View product and system information, including list of
options, if any; view network settings; view/adjust Date and
Time settings*; and check for firmware updates when
connected to a network that is connected to the Internet.
*
Time Zone change requires special procedures (Section 5.5).
View and configure network and serial communications.
Teledyne API – Model T400 O
nd sensor
Analyzer 083730400A DCN8130
3
LOCATION
Section 2.4.1
Section 2.4.2
Section 2.4.3
Section 4
Section 2.4.5
Section 2.5
Section 2.5.1
Section 2.5.2
Section 2.5.3
Section 4.3
Section 2.5.5
Section 2.5.6
Section 2.5.7
Section 2.5.8
Section 2.5.9
Section 2.5.10