Table of Contents
Advertisement
Model 400E Ozone Analyzer
Instruction Manual
For more information about setting up and performing these calibration operations,
see Section 7.
For more information concerning the Zero/Span Valve Options, see Section 5.3.
6.3. Set-Up Mode
The SETUP Mode contains a variety of procedures and task that are used to
configure the analyzer's various hardware and software features, and to read data
from the internal data acquisition system (iDAS).
Any changes made to a variable during one of the following
procedures is not acknowledged by the instrument until the
If the
will beep alerting the user that the newly entered value has
6.3.1. RNGE Menu
This menu contains instructions for configuring the analyzer's Analog Output data
channels. For detailed information about this topic see Sections 6.4 and 6.5 of this
manual.
6.3.2. Automatic Calibration (AutoCal)
The AutoCal feature allows the M400E to automatically operate any of the
Zero/Span Valve options. Information on setting up AutoCal is in Section 7.6.
6.3.3. Password Enable / Security Mode (PASS)
The M400E provides password protection of the calibration and setup functions to
prevent incorrect adjustments. When the passwords have been enabled, the system
will prompt the user anytime a function is requested requiring password access.
There are three levels of password protection, which correspond to operator,
maintenance, and configuration functions. Each level allows access to the all of the
previous levels functions.
P/N 04316 Rev: B
ENTR
EXIT
key is pressed before the
NOTE
Key is pressed.
ENTR
been lost.
Operating Instructions
key, the analyzer
61
Advertisement
Table of Contents
