Reset Traffic-Limit Vlan - H3C s3100 series Command Manual

Parameter
inbound: Specifies to clear the statistics on the inbound packets.
acl-rule: ACL rules to be applied. This argument can be the combination of multiple ACLs. For more
information about this argument, refer to
Description
Use the reset traffic-limit command to clear the traffic policing statistics on all the packets matching
specific ACL rules, or packets that match specific ACL rules and are of a port group or pass a port.
Related command: traffic-limit.
Only H3C S3100-EI series switches support this command.
Example
# Clear the traffic policing statistics on packets matching ACL 2000 and passing Ethernet 1/0/1
(assuming that the current device is an S3100-EI series switch).
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Ethernet1/0/1
[Sysname-Ethernet1/0/1] reset traffic-limit inbound ip-group 2000

reset traffic-limit vlan

Syntax
reset traffic-limit vlan vlan-id inbound acl-rule
View
System view
Parameter
vlan-id: VLAN ID, in the range 1 to 4094.
inbound: Specifies to clear the statistics on the inbound packets.
acl-rule: ACL rules to be applied. This argument can be the combination of multiple ACLs. For more
information about this argument, refer to
Description
Use the reset traffic-limit vlan command to clear the statistics on packets of a VLAN.
Related command: traffic-limit vlan.
Table 1-9 and Table 1-10.
Table 1-9 and Table 1-10.
1-30