System Debugging Commands; Debugging - H3C s3100 series Command Manual

View
Any view
Parameter
None
Description
Use the display version command to display the version information about the switch system.
Specifically, you can use this command to check the software version and release time, the basic
hardware configuration, and some other information about the switch.
Example
# Display the version information of the system.
<Sysname> display version
H3C Comware Platform Software.
Comware Software, Version 3.10, Alpha 2101
Copyright (c) 2004-2007 Hangzhou H3C Technologies Co., Ltd. All rights reserved.
H3C S3100-26TP-EI-W uptime is 0 week, 0 day, 19 hours, 40 minutes
H3C S3100-26TP-EI-W with 1 Processor
64M bytes SDRAM
8M bytes Flash Memory
Config Register points to FLASH
Hardware Version is REV.A
Bootrom Version is 506
CPLD Version is 001
[Subslot 0] 24FE
[Subslot 1] 1GE
[Subslot 2] 1GE

System Debugging Commands

debugging

Syntax
debugging module-name [ debugging-option ]
undo debugging { all | module-name [ debugging-option ] }
View
User view
Parameter
module-name: Module name.
debugging-option: Debugging option.
all: Specifies to disable all debugging.
Hardware Version is REV.A
Hardware Version is REV.A
Hardware Version is REV.A
1-7