H3C s3100 series Command Manual page 998

Table 1-5 Description on the fields of the display ipv6 interface brief command
Field
*down: administratively
down
(s) : spoofing
Interface
Physical
Protocol
IPv6 Address
display ipv6 nd detection
Syntax
display ipv6 nd detection
View
Any view
Parameters
None
Description
Use the display ipv6 nd detection command to display ND detection configuration.
Refer to the ipv6 nd detection enable command and ipv6 nd detection trust command for related
configuration.
Among S3100 series switches, only S3100-EI series switches support the two commands.
The interface is down, that is, the interface is disabled by using the
shutdown command.
Spoofing attribute of the interface, that is, the link protocol state of the
interface is up, but the link does not exist, or the link is established on
demand, instead of being permanent.
Name of the interface
Interface link state:
*down: Indicates the VLAN interface is administratively down; that
is, the interface is shut down using the shutdown command.
down: Indicates the VLAN interface is administratively up but its
physical state is down; that is, no port in the VLAN is up, which
may be caused by a link failure.
up: Indicates the administrative and physical states of the VLAN
interface are both up.
Link protocol state of an interface
down: Indicates the link layer protocol state of the VLAN interface
is down, generally because no IP address is configured.
up: Indicates the link layer protocol state of the VLAN interface is
up.
IPv6 address of the interface (If no address is configured for the
interface, "Unassigned" will be displayed.)
1-9
Description