Speed - H3C s3100 series Command Manual

You can use the display port combo command to check the states of the two ports forming a combo
port. The one in active state is currently enabled and the one in inactive state is currently disabled.
For the two ports forming a combo port, executing the shutdown command on the active port changes
the port state to inactive; executing the undo shutdown command on the inactive port changes the port
state to active.
Example
# Disable and then enable port Ethernet 1/0/1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] shutdown
[Sysname-Ethernet1/0/1] undo shutdown

speed

Syntax
speed { 10 | 100 | 1000 | auto }
undo speed
View
Ethernet port view
Parameter
10: Specifies the port speed to 10 Mbps.
100: Specifies the port speed to 100 Mbps.
1000: Specifies the port speed to 1,000 Mbps (only available to GigabitEthernet ports).
auto: Specifies the port speed to the auto-negotiation mode.
Description
Use the speed command to set the port speed.
Use the undo speed command to restore the port speed to the default setting.
By default, the port speed is in the auto-negotiation mode.
Note that you can only specify the 1000 and auto keyword for Gigabit Ethernet ports.
Related command: duplex.
Example
# Set the speed of Ethernet 1/0/1 to 10 Mbps.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
1-29