Display Device - H3C s3100 series Command Manual

View
Any view
Parameter
unit-id: Unit ID of a switch, the value can only be 1.
Description
Use the display cpu command to display the CPU usage.
Example
# Display the CPU usage of this switch.
<Sysname> display cpu
Unit 1
Board 0 CPU busy status:
16% in last 5 seconds
16% in last 1 minute
16% in last 5 minutes
Table 3-2 Description for the fields of the display cpu command
Field
CPU busy status
16% in last 5 seconds
16% in last 1 minute
16% in last 5 minutes

display device

Syntax
display device [ manuinfo | unit unit-id ]
View
Any view
Parameter
manuinfo: Specifies to display the manufacture information of the specified switch.
unit-id: Unit ID of a switch, the value can only be 1.
Description
Use the display device command to display the information, such as the module type and operating
status, about each board (main board and sub-board) of a specified switch.
You can use this command to display the following information about each board, including slot number,
sub-slot number, the number of ports, versions of PCB, FPGA, CPLD and Boot ROM software, address
learning mode, interface board type, and so on.
CPU usage status.
The CPU usage in the last five seconds is 16%.
The CPU usage in the last one minute is 16%.
The CPU usage in the last five minutes is 16%.
3-3
Description