Display Port Combo; Display Unit - H3C s3100 series Command Manual

Table 1-4 Description on the fields of the display loopback-detection command
Port Ethernet1/0/1 loopback-detection is running
system Loopback-detection is running
Detection interval time is 30 seconds
There is no port existing loopback link

display port combo

Syntax
display port combo
View
Any view
Parameter
None.
Description
Use the display port combo command to display the combo ports on the current device.
Example
# Displays current the combo ports on the device.
<Sysname> display port combo
Combo-group
1
2
For the two ports forming a combo port, the one in active state is currently enabled and the one in
inactive state is currently disabled. You can refer to the
two ports.
For information about combo port, refer to H3C S3100 Series Ethernet Switch Installation Manual.

display unit

Syntax
display unit unit-id interface
Field
Active
GigabitEthernet1/1/2
GigabitEthernet1/2/2
Loopback detection is enabled on the
Ethernet1/0/1.
Loopback detection is enabled globally.
Time interval for loopback detection is 30
seconds.
No loopback port exists.
Inactive
GigabitEthernet1/1/1
GigabitEthernet1/2/1
shutdown command to change the state of the
1-12
Description