H3C s3100 series Command Manual page 706

Table 1-1 Description on the fields of the display poe interface command
Field
Port power enabled
Port power ON/OFF
Port power status
Port power mode
Port PD class
Port power priority
Port max power
Port current power
Port average power
Port peak power
Port current
Port voltage
# Display the PoE status of all ports.
<Sysname> display poe interface
PORT INDEX
Ethernet1/0/1
Ethernet1/0/2
Ethernet1/0/3
Ethernet1/0/4
Ethernet1/0/5
Ethernet1/0/6
......
<Omitted>
Table 1-2 Description on the fields of the display poe interface command
Field
PORT INDEX
POWER
ENABLE
PoE is enabled on the port
The power on the port is on/off
PoE status on the port:
user command set port to off: PoE to the port is turned off by the
user
Standard PD was detected: A standard PD is detected
Legacy PD was detected: A non-standard PD is detected
detection is in process: PDs are being detected
PoE mode on the port:
signal: PoE through the signal cable
Class of power to the PD
PoE priority of the port:
critical: The highest
high: High
low: Low
The maximum available power on the port
The current power on the port
The average power on the port
The peak power on the port
The current on the port
The voltage on the port
POWER ENABLE MODE
off disable signal
off disable signal
off disable signal
off disable signal
off disable signal
off disable signal
Port index
Power status on the port: ON/OFF
PoE enabled/disabled status on the port
Description
PRIORITY STATUS
low user command set port to off
low user command set port to off
low user command set port to off
low user command set port to off
low user command set port to off
low user command set port to off
Description
1-2