H3C s3100 series Command Manual page 1084

Field
LLDP-MED extend TLV
lldp admin-status
Syntax
lldp admin-status { disable | rx | tx | txrx }
undo lldp admin-status
View
Ethernet interface view
Parameters
disable: Specifies the Disable mode. A port in this mode does not send or receive LLDPDUs.
rx: Specifies the Rx mode. A port in this mode receives LLDPDUs only.
tx: Specifies the Tx mode. A port in this mode sends LLDPDUs only.
txrx: Specifies the TxRx mode. A port in this mode sends and receives LLDPDUs.
Description
Use the lldp admin-status command to specify the LLDP operating mode for a port or all the ports in a
port group.
Use the undo lldp admin-status command to restore the default LLDP operating mode.
The default LLDP operating mode is TxRx.
Examples
# Configure the LLDP operating mode as Rx for Ethernet1/0/1.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] lldp admin-status rx
lldp check-change-interval
Syntax
lldp check-change-interval interval
undo lldp check-change-interval
View
Ethernet interface view
MED related LLDP TLVs, including:
Capabilities TLV
Network Policy TLV
Extended Power-via-MDI TLV
Location Identification TLV
Inventory TLV, which can be hardware revision TLV, firmware
revision TLV, software revision TLV, serial number TLV,
manufacturer name TLV, model name TLV, and asset id TLV.
1-14
Description