Examples
# Enable MLD Snooping in VLAN 2 and configure the source IPv6 address of MLD reports sent by the
MLD Snooping proxy in VLAN 2 to FE80:0:0:1::1.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping report source-ip fe80:0:0:1::1
mld-snooping router-aging-time
Syntax
mld-snooping router-aging-time interval
undo mld-snooping router-aging-time
View
VLAN view
Default Level
2: System level
Parameters
interval: Dynamic router port aging time, in seconds. The effective range is 1 to 1,000.
Description
Use the mld-snooping router-aging-time command to configure the aging time of dynamic router
ports in the current VLAN.
Use the undo mld-snooping router-aging-time command to restore the default setting.
By default, the dynamic router port aging time is 260 seconds.
This command takes effect only if MLD snooping is enabled in the VLAN.
Related commands: mld-snooping enable, router-aging-time.
Examples
# Enable MLD snooping and set the aging time of dynamic router ports to 100 seconds in VLAN 2.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping router-aging-time 100
2-21