Probe-Failtimes - H3C s3100 series Command Manual

To perform an FTP test successfully, the configured password must be consistent with the FTP
user password configured on the server.
This command applies to FTP tests only.
Examples
# Set the password for logging into the FTP server as hwping in an FTP test.
<Sysname> system-view
System View: return to User View with Ctrl+Z
[Sysname] hwping administrator ftp
[Sysname-hwping-administrator-ftp] test-type ftp
[Sysname-hwping-administrator-ftp] password hwping

probe-failtimes

Syntax
probe-failtimes times
undo probe-failtimes
View
HWPing test group view
Parameters
times: Number of consecutive failed probes, in the range of 1 to 15.
Description
Use the probe-failtimes command to configure the number of consecutive times the probe fails before
the switch sends out a trap message.
Use the undo probe-failtimes command to restore the default.
By default, the switch sends a trap about probe failure each time when a probe fails.
Examples
# Configure the switch to send a trap after the probe in an ICMP test fails for three consecutive times.
<Sysname> system-view
System View: return to User View with Ctrl+Z
[Sysname] hwping administrator icmp
[Sysname-hwping-administrator-icmp] test-type icmp
[Sysname-hwping-administrator-icmp] probe-failtimes 3
1-27