H3C s3100 series Command Manual page 991

Parameters
number: Maximum number of DHCPv6 snooping entries that can be learned by the interface,in the
range of 0 to 1023.
Description
Use the dhcp-snooping ipv6 max-learning-num command to configure the maximum number of
DHCPv6 snooping entries that can be learned on the interface.
Use the undo dhcp-snooping ipv6 max-learning-num command to restore the default.
By default, the number of DHCPv6 snooping entries that an interface can learn is not limited.
Among S3100 series switches, only S3100-EI series switches support the two commands.
Examples
# Set the maximum number of DHCPv6 snooping entries that can be learned on Layer 2 Ethernet
interface Ethernet 1/0/1 to 1000.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] dhcp-snooping ipv6 max-learning-num 1000
dhcp-snooping ipv6 trust
Syntax
dhcp-snooping ipv6 trust
undo dhcp-snooping ipv6 trust
View
Layer 2 Ethernet interface view
Parameters
None
Description
Use the dhcp-snooping ipv6 trust command to configure a port as a trusted port.
Use the undo dhcp-snooping ipv6 trust command to restore the default state of a port.
All ports are untrusted by default.
1-2