View - H3C s3100 series Command Manual

Examples
# Configure a scheduled task so that PoE can be enabled on the device at eight AM from Monday to
Friday.
[Sysname-job-phone] time 1 repeating at 8:00 week-day Mon Tue Wed Thu Fri command poe enable
# Configure a scheduled task so that PoE can be disabled on the device on sixth April 2008.
[Sysname-job-phone] time 2 at 8:00 2008/04/06 command undo poe enable
# Configure a scheduled task so that PoE is disabled on the device five hours after the command is
configured.
[Sysname-job-phone] time 5 one-off delay 5:00 command undo poe enable

view

Syntax
view view
undo view
View
Scheduled task view
Default Level
3: Manage level
Parameters
view: View name, a string of 1 to 90 characters, used to specify in which view the specified command(s)
in a scheduled task will be executed.
Description
Use the view command to specify a view where the specified command(s) are to be executed.
Use the undo view command to remove the view existing in a scheduled task.
Note that:
If you do not specify a view for a scheduled task, the command specifies the view; if you have
specified a view for a scheduled task, the command modifies the view.
You can specify only one view for each scheduled task, and all the commands in the task will be
executed in the view.
Examples
# Specify, and modify a view and then display the configuration.
[Sysname] job saveconfig
[Sysname-job-saveconfig] view Ethernet1/0/2
[Sysname-job-saveconfig] display this
#
job saveconfig
view Ethernet1/0/2
#
4-4