H3C s3100 series Command Manual page 435

[Sysname] local-server nas-ip 10.110.1.2 key aabbcc
nas-ip
Syntax
nas-ip { ip-address | ipv6 ipv6-address }
undo nas-ip
View
RADIUS scheme view
Parameters
ip-address: Source IP address for RADIUS messages, an IP address of this device. This address can
neither be the all 0's address nor be a Class-D address.
ipv6 ipv6-address: Specifies an IPv6 address. It must be an address of the device and must be a
unicast address that is neither a loopback one nor a link-local one.
Description
Use the nas-ip command to set the source IP address of outgoing RADIUS messages.
Use the undo nas-ip command to remove the source IP address setting.
By default, the IP address of the outbound interface is used as the source IP address of RADIUS
messages.
The nas-ip command in RADIUS scheme view has the same function as the radius nas-ip command
in system view; and the configuration in RADIUS scheme view takes precedence over that in system
view.
You can set the source IP address of outgoing RADIUS messages to avoid messages returned from
RADIUS server from being unable to reach their destination due to physical interface trouble. It is
recommended to use a Loopback interface address as the source IP address.
Related commands: display radius scheme, radius nas-ip.
Examples
# Set source IP address 10.1.1.1 for outgoing RADIUS messages in RADIUS scheme radius1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] radius scheme radius1
New Radius scheme
[Sysname-radius-radius1] nas-ip 10.1.1.1
# Set the IPv6 address for the device to use as the source address of the RADIUS packets to 1:1::2:2.
<Sysname> system-view
1-46