Display Qos-Vlan - H3C s3100 series Command Manual

Only H3C S3100-EI series switches support this command.
Example
# Display all the QoS-related configurations of port group 1 (assuming that the current device is an
S3100-EI series switch).
<Sysname> display qos-port-group 1 all
Port-group 1 traffic-limit
Inbound:
Matches: Acl 3001 rule 0
Target rate: 128 Kbps
Exceed action: drop
meter-statistic not running
Refer to Table 1-1

display qos-vlan

Syntax
display qos-vlan [ vlan-id ] { all | mirrored-to | traffic-limit | traffic-priority | traffic-redirect |
traffic-statistic }
View
Any view
Parameter
vlan-id: VLAN ID, in the range 1 to 4094. If this argument is not specified, the QoS configuration
performed for all the VLANs is displayed.
all: Displays all the QoS-related configurations performed for packets of a VLAN.
traffic-limit: Displays the traffic policing configuration performed for packets of a VLAN.
traffic-priority: Displays the priority marking configuration performed for packets of a VLAN.
traffic-redirect: Displays the traffic redirecting configuration performed for packets of a VLAN.
traffic-statistics: Displays the traffic accounting configuration performed for packets of a VLAN.
Description
Use the display qos-vlan command to display the QoS-related configuration performed for a VLAN.
Only H3C S3100-EI series switches support this command.
running
for the description on the output fields.
1-15